Loctite E-120HP Hysol - 50 ml - 2:1
1
-
7
$32.99
8
+
$31.79
Estimated lead time for quantities greater than what is Available Now is expected to be under 2 weeks.
If there is an Available Now quantity listed above, it indicates our quantity in stock. Orders placed today for this quantity or less are expected to ship the next business day.
Sold individually
Loctite E-120 HP Hysol is a aerospace grade adhesive that offers ultra high strength (~4300 psi of shear strength). This adhesive is also considered a high temperature adhesive and it can resist up to ~250°F. E-120 HP has the longest work life we offer of 120 minutes. The cure time is listed at a minimum of 3 hours but we highly suggest you let it cure for a full 24 hours at room temperature. Need a cheat sheet? See our Adhesives Table. Need help with surface preparation? Read our instructions below.
Rock West Composites will NOT return or refund adhesive orders.
VIEW INSTRUCTIONS
INSTRUCTIONS - QUICK AND SIMPLE
- Be sure to prepare both surfaces by roughing or sanding. To sand the inner diameter of a carbon fiber tube (or other material) use a properly sized Abrasive Flex Hone.
- Follow this by degreasing the part with isopropyl alcohol or acetone and cleaning thoroughly. It is most common to bond to the ID of our carbon tubes rather than the OD given the tighter dimensional tolerances (+/-0.004” vs. +/-0.012”). 120 grit sand paper should work fine
- Minimize galvanic corrosion between two dissimilar materials (aluminum included) by using Bond Line Controller. Our glass beads come in various diameters and can be mixed into the adhesive / epoxy during mixing. This serves 2 purposes, 1- forces a consistent bond line between two concentric parts and 2- Ensures isolation of the two materials
- Choose the correct size Bond Line Controller - This depends on the gap between your two parts. If you are specifying this gap to a machinist, we would typically recommend a bond line (gap) of around 0.008” to 0.013” and use product #1031 and #1030 respectively. Also, it is recommended for every 3oz. of adhesive you use 2g of Bond Line. *Note - Some parts may be forced into position if the bond line bead matches the bond gap identically. This is not always necessary to ensure concentricity.
- Some of our adhesives (titled "Dual Cartridge") require both a gun (Applicator) and dispensing nozzles (Mix Nozzles).
INSTRUCTIONS - LONG AND THOROUGH (click to view and print)
Additional Information
| P/N | 1027-50 |
|---|---|
| Mix Ratio | 2:1 |
| Adhesive Chemistry | Epoxy |
| Adhesive Mix Method | Dispensing Gun |
| Adhesive Shear Strength (psi) | 4000 - 4499 |
| Size | 50ml |
| Adhesive Use | High Temp, Chemical Resistant, Aerospace |
| Adhesive Viscosity | 25,000 to 50,000 |
| Application | Adhesive Epoxies |
| Brand | Loctite |
| Weight | 0.16 |